Help with flasher cable

[supergdl]

Hi guys,
i've got a big problem with my built flasher cable!

from about 1 week , when i try to read/write flash Rolis 4.77 and 4.78b6 say:
"Preloader Boot Error, check cable and connection, cable supply"


what should i do?

thanks in advance

supergdl - from Italy

[tamz3315]

Check your LPT Input/Output Range in your LPT port using Lpt 1 in Rolis flasher it must be 0378-037F

or try to use knok flasher there is a 3 lpt port choices there, trial and error....

Hope it may solve the problem...

anyway do you got a 5110 full flash?

[[RedHat]]

already done that but still got problems. By the way, i'm using dejan scheme v1.7:grin:

[pincon_benoist]

Hi,

if your cable is right :

Did you try under win2k or Xp ? in this case, Userport must be used in order to enable direct acces to ports for the software.
(didn't work properly for me under Xp, so using win 9x/Me may be the best option).

Is the connector properly fitted in the phone ?
Sometimes the contacts are not perfect, on my 3210 it needed to be hold by hand (got damaged after a few flashes)

I'm experiencing this problem with my 3310 sw 5.03 (didn't respond) but it works with others 3310 phones (and 3210) whitout problems ... strange

Try with another phone (reading !) : if it fails maybe the cable isn't good.

[pico]

hi, a small tip to stop you having to hold the cable all through flashing; just put an elastic band around phone/connector :)
if you have bad connection with 33xx type phones, wedge a small piece of paper between connector/phone to make the connector stay in place.

[[RedHat]]

i have the same problem and i've tried desolder and soldering the parts again. can it be the chip. Does the chip have many type, the manufacturing packaging type i mean?