View Full Version : hot air rework station defect
anthony_bud
31-12-2002, 10:15 AM
hey there!
my ordinary Aeolus 850 rework station (made in china) is malfunctioning.
recently, it always turns the air flow off itself after just over a minute everytime i'm using it.
can anyone have some insight on the matter?
are there available parts for these?
mickey blue eye
31-12-2002, 11:59 AM
Thermal cut off???
anthony_bud
02-01-2003, 04:17 AM
i don't know if that's the term for it - thermal cutoff.
what's always happening is that when i switch it on the air flow is good. the heat is turning on and off. after just over a minute or so the air flow turns off and doesn't turn on again.
i think it happens when the filament is already hot.
any insight?
Andie
04-01-2003, 11:38 PM
hi,
there is a thermal inside the filament, you can try to move it bit away from the filament perhaps 1 cm and if still doesnt work then the thermal is damaged and you might need to replace the filament or just the thermal ( i dont know if i they selling the thermal only ).
when the filament is cutoff the led on heater will blink fast.
hope this can help
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.