PLZZZZZ HELP ME !

[||Joe]

HIya all,

I bought some Flasher cables yesterday. plugged it in at the back of my "PC" in the printer port and then loaded up Nokia Tool. after connecting the flasher cable to my 6210 i clicked on Read ME, and after about 6-7 secs it sed "Phone not connected"

Can anyone plz tell why it is doing this .

thanx very much.

NOTORIOUS !

[||Joe]

it is seem that you may be reset your pc's cmos printer port.

[||Joe]

lollll....
i have laught for over 30 minutes
u have bought a flashing cable ...
not an m-bus cable
when u wanna read a phone u must use an m2bus cable not an flashing cable ...
i use the flashing cable for unlocking phone ..
for exmple u have the 6210 phone ...
u just put the cable as u have already did on the back of the computer ... after this operation u just conect it to the back of the phone ... open an program for unlocking the phone by flashing ... not some old modeles (not versions)

of course u must check the configuration on the bios of the computer ..
the perfect computer configuration is :
1 X processor at least 333 MHz
1 X 128 MRam but u can use 64 an 32 too ... but is high risk for the phone

and never ever run another program when u flash a phone

if u have more problems please contact me on the [email protected]

take care of your phone !