3310 apply soft but no power

[magdy_elnady]

hi my all friends , please help me ..
i have 3310 no power , i tried full flash with rolis 4.77 & ppm,mcu with widdp 4.00 ,
but it does not work, but it apply the flash normally.
thank u very much for help me.

[businesscol]

have you tried opening up the phone and looking at your hardware, look for battery conector (metal piece behind the top of the LCD screen) You'll need a T6 torx screwdriver for this. If this is not the problem then it may be the PCB components and you'll have to hope its under warranty unless you're a TECH GENIUS. Hope this is of some help.

[magdy_elnady]

thank u for ur reply,
but u must know when u write flash normally that means hardware is ok (power supply ic,hagar,flash rom & ram):)
urs MAGDY ( icq 174786211 )
----welcome---

[WildSwan]

What flasher software did you really used?

WinDDP and Rolis cables are not the same. Rolis uses the Dejan Classic cable while WinDDP uses a Dejan Box.

What did you use?

A dead phone after flashing means you have not flashed it properly or the flash file you used is defective.

Try flashing it again using your backup or other known good flash file. Observe the propper addresses.


Originally posted by magdy_elnady
hi my all friends , please help me ..
i have 3310 no power , i tried full flash with rolis 4.77 & ppm,mcu with widdp 4.00 ,
but it does not work, but it apply the flash normally.
thank u very much for help me.

[magdy_elnady]

thank u man , but i know flasher & its progs ,dejan & its progs.
i was flash it with orginal file from working one.
what can i do????