PDA

View Full Version : Using Dejan's 1.03 MCU&PPM Help!!!!!!



||Joe
01-09-2001, 03:16 AM
Hi,
What i'm about to ask maybe a stupid question but can you please help.
When o read both MCU and PPM to a files. Can o rename the ppm file (filename.D) to filename.fls and then upload it to my phone using dejan's 1.0, since i don't have the box?

||Joe
01-09-2001, 10:48 AM
The answer is 99% yes. 1% is that Dejan file starts with for exampl e 4440 0000 0000 0000 and after that word PPM and .....

Real PPM file starts with word PPM. Just cut all before PPM and all will be OK. Of course you must know start address for PPM image in your phone ... and after uploading you will have not network coverage ;-((( I asked today Viper about eeprom recalculation with him program ... and I'll awaiting for the answer

||Joe
01-09-2001, 03:23 PM
Thanks for replaying.....
So if im using a 3310 4.24 please advise me if the folloing passes are correct:
3310 V4.06 to 4.45
Firmware 200000 - 330000
PPM 330000 - 3D0000 (Info colected on www.mynokia.ch (http://www.mynokia.ch))
EEprom 3D0000 - 400000
Full Backup 200000 - 400000

1st Full backup of the of the original phone phone (200000-400000)
2nd Take the ppm and mcu out of the bin file that i what to upload.
3rd Edit the bin as you sayd, so that it sarts with PPM (what hex editor are you using)??????????
4th Upload the renamed xxxxx.D to xxxxxx.fls the phone using dejan's 1.0 starting the address 330000-3d0000.
5th Full backup of the of the phone phone (200000-400000) and go to the nfree soft to calculate checksum (does nfree work ok with 3310)??????????
6th full upload to phone (200000-4000000)

Please tell me if this is correct!!!
Thanks and keep up the good work.

||Joe
02-09-2001, 04:19 AM
I tryed the above sequence and it didn't work!!!!!!!!!!!
After changing the hex file as you said (removing all before the word "PPM")
flashed the phone starting on 330000 and then he says "Contact service". I tryed do use nfree and it didn't workd also.
Any help.

Ps: Of course i flashed back with the original flash and the phone is ok!!!!1

||Joe
02-09-2001, 02:11 PM
The eeprom contains checksums for the software version, MCU and PPM area....
So, it won't work.

||Joe
02-09-2001, 03:53 PM
HI ALL
PLEASE IF YOU HAVE AN ANSWER TO TKIS
NOKIA 8210 FACTORY NEW< V.5.28
I HAVE TO DEGRADE TO V.5.25 DONT ASK ME WHY?
EVERY THING WENT NORMAL WITH DEGRADING 5,27&5.26

BUT ONLY V.5.28 DEGRADED ALMOST TO THE END OF THE
PROCCES THE N I GOT A MESSAGE ( MS_ID error)
when you check the phone it gives CONTACT SERVICE
WHEN I RE ISTALL V.5.28 THE PHONE GOES BACK TO NORMAL,

SO WHY ONLY WITH V.5.28 I CANT DEGRADE

||Joe
19-09-2001, 03:33 PM
Do you have the box, or if not pls help me how to use the PPM MCU by dejan pls help Thanks Adrian