damjang
18-03-2003, 09:40 AM
I found this:
Nokia 8310 Software Changes Made From Version 5.80 to 6.04:
- Improvement to page mode change handling on PCCCH cell
- Handling of GPRS connection mode change during active voice call
- Improvement to detach making in when needed mode if all PDP contexts deactivated during RAU
- Improvements to SI13 refresh
- Improvement to cell reselection using C2 parameters
- In NMO I when MS received Attach or RAU Reject with causes ?MSC temporarily not reachable?,
?Network failure? or ?Congestion? MM state was incorrectly set as ?NOT_UPDATED?
- Handling of reject causes #3 "Illegal MS" and #6 "Illegal ME" changed according to CR420
- PCS1900 GPRS uplink power level calculation used gamma_0 value of 33. That was an assumption
from rel98 specs and is now corrected to be 36 as stated in rel99 spec 05.08.
- Modifications for PH to work correctly if some other SI than SI13 is received in TC=4.
- In NMO I when combined Attach/RAU was ongoing and NW did not answer,
MO call could be not available for a while.
- Packet Uplink Assignment validity check corrected in case of Single
Block Allocation and Packet Uplink Assignment with TA index present
- Improvement to MO-call during LCS measurements
- Improvements to handling of long SMSs
- Improvement to cases where network sends Immediate Assignment Reject
to CS call when TBF has been suspended
- Improvement to minimum QoS handling
- Further improvements to weak field functionality
- Improvement to functionality in case where Detach and Attach where
send in same TBF
- Changed SMS memory available reporting to network. Now ME memory is
always included
- Improved empty SMS handling and to SMS validity check
- Improvement to dedicated mode establishment
- Incorrect parameter validation in calculation of full PSI schedule
cycle resulted in valid parameter values being rejected and to a
failed cell reselection. This happened in case PSI_COUNT_HR = 0.
- If serving cell became unsuitable because of RLA_P < HCS_THR but C32
value was still higher than for all neighbour cells, cell was not changed
- Target cell SI was sometimes read from EXT-BCCH while it should have
been read from BCCH and vice versa. This sometimes caused unnecessary delay.
- Improvement to case where SIM Toolkit application?s SIM refresh
changes last registered network and MM restart is requested. After SIM
refresh was completed, the phone selected same network where it was
registered prior to SIM refresh.
- Improvement to Power Off Detach sending during active data transfer
- Improvement to flexible operator name indication
- Improvement to cell change during data transfer
- Improvement to GPRS attach/detach collision handling
- Changed page mode handling in case of downlink immediate assignment
where IA Rest Octects are not present
- Improvement to GPRS detach procedure. Combined detach type is now
always used when needed.
- Improvement to PLMN search time and network refresh procedure
- Improvement to Extended Paging handling in non-DRX mode
- Improvement to manual network selection
- Improvements to Location Services
- Improvement to handling Routing Area Update Reject cause #14
- Improvements to Fixed Dialling Number feature
- MS does not anymore wait for DETACH ACCEPT if MT DETACH has a fatal cause
- Improvements to polling queue handling on MAC
- Improvements to MO/MT calls handling in idle mode with always online
enabled after failed LA/RA.
- Chinese font updated
- Calendar alarms work correctly after synchronization with PC Suite
- 2 ringing tones changed in APAC language packages
- Signal bar shows the signal strength more accurate
- Operator list updated
-----------
Where I can find this fw?
damjang
Nokia 8310 Software Changes Made From Version 5.80 to 6.04:
- Improvement to page mode change handling on PCCCH cell
- Handling of GPRS connection mode change during active voice call
- Improvement to detach making in when needed mode if all PDP contexts deactivated during RAU
- Improvements to SI13 refresh
- Improvement to cell reselection using C2 parameters
- In NMO I when MS received Attach or RAU Reject with causes ?MSC temporarily not reachable?,
?Network failure? or ?Congestion? MM state was incorrectly set as ?NOT_UPDATED?
- Handling of reject causes #3 "Illegal MS" and #6 "Illegal ME" changed according to CR420
- PCS1900 GPRS uplink power level calculation used gamma_0 value of 33. That was an assumption
from rel98 specs and is now corrected to be 36 as stated in rel99 spec 05.08.
- Modifications for PH to work correctly if some other SI than SI13 is received in TC=4.
- In NMO I when combined Attach/RAU was ongoing and NW did not answer,
MO call could be not available for a while.
- Packet Uplink Assignment validity check corrected in case of Single
Block Allocation and Packet Uplink Assignment with TA index present
- Improvement to MO-call during LCS measurements
- Improvements to handling of long SMSs
- Improvement to cases where network sends Immediate Assignment Reject
to CS call when TBF has been suspended
- Improvement to minimum QoS handling
- Further improvements to weak field functionality
- Improvement to functionality in case where Detach and Attach where
send in same TBF
- Changed SMS memory available reporting to network. Now ME memory is
always included
- Improved empty SMS handling and to SMS validity check
- Improvement to dedicated mode establishment
- Incorrect parameter validation in calculation of full PSI schedule
cycle resulted in valid parameter values being rejected and to a
failed cell reselection. This happened in case PSI_COUNT_HR = 0.
- If serving cell became unsuitable because of RLA_P < HCS_THR but C32
value was still higher than for all neighbour cells, cell was not changed
- Target cell SI was sometimes read from EXT-BCCH while it should have
been read from BCCH and vice versa. This sometimes caused unnecessary delay.
- Improvement to case where SIM Toolkit application?s SIM refresh
changes last registered network and MM restart is requested. After SIM
refresh was completed, the phone selected same network where it was
registered prior to SIM refresh.
- Improvement to Power Off Detach sending during active data transfer
- Improvement to flexible operator name indication
- Improvement to cell change during data transfer
- Improvement to GPRS attach/detach collision handling
- Changed page mode handling in case of downlink immediate assignment
where IA Rest Octects are not present
- Improvement to GPRS detach procedure. Combined detach type is now
always used when needed.
- Improvement to PLMN search time and network refresh procedure
- Improvement to Extended Paging handling in non-DRX mode
- Improvement to manual network selection
- Improvements to Location Services
- Improvement to handling Routing Area Update Reject cause #14
- Improvements to Fixed Dialling Number feature
- MS does not anymore wait for DETACH ACCEPT if MT DETACH has a fatal cause
- Improvements to polling queue handling on MAC
- Improvements to MO/MT calls handling in idle mode with always online
enabled after failed LA/RA.
- Chinese font updated
- Calendar alarms work correctly after synchronization with PC Suite
- 2 ringing tones changed in APAC language packages
- Signal bar shows the signal strength more accurate
- Operator list updated
-----------
Where I can find this fw?
damjang