3210 Won't Flash

[cyrubz]

HELLO ALL,

I TRY TO FLASH 3210 BUT IT SAYS TX-HIGH SOMETIMES TX-LOW
ALREADY CLEAN THE CONTACT BUT STILL GET SAME ERROR MESSAGE. CAN U EXPLAIN ME THIS HAPPEND?




THANKS

SORRY FOR MY ENGLISH

[filka97]

which software you use rollis flasher?

[pico]

did you charge the battery?

[cyrubz]

yes i used rollis 4.7 and knok95 but still get the sme problem. the battery is fully charge

[pico]

3210 factory made cables will auto power on the phone for you, no need to press button yourself when rolis asks that.
or maybe try to remove battery and just insert Nokia charger when asked to "power on".
just some ideas..
:)

[cyrubz]

thanks for your advice but i already did that and nothing works.
when i connect the battery it says tx-high and sometimes tx-low...

[sirhc_desktop]

@cyrubz

try to clean the contacts of the pins of your cables
maybe its dirty...

i know it will power on when you connect the cable...
what you have to do is to locate the BTEMP and put an insulator
on it, cause it causes the phone to auto on...

i FLASH a 3210 and it works for me

[cyrubz]

hello guys:


thanks for your advise ill do that... ill paste my reply soon...



thanks again.....

[flashed]

Check battery terminal pins arnt bent, spent two days on a 5210 that wouldnt flash and it was the pins!!!

[chunkhead]

Change the delay index in rolis flasher! It works for me on 3 with phones displaying that! But try them all 1-5! Hope this helps!;)