PDA

View Full Version : 6310i latest firmware 5.5



terry
29-03-2003, 02:05 AM
changes
Bluetooth:
• Improved indications and handling of multiple calls
• ALS (Alternate Line Service) indications improved
• Support for WinXP
• BT startup behavior improved
• BT handing of non expected data from PC-Suite
• Stability of BT authentication procedure improved
• Switch from slave to master improved
• Noise reduction in BT audio enhanced
• BT stability improved in general
• Query ‘Continue call’ has been removed when transferring audio in Hands free-Profile.
• Entering of BT sniff mode improved
• Sniff mode stability improved
• Park mode handling improved
• BT inquiry duration improved

Calendar
• Writing a meeting note improved in Hebrew language → Operator: Partner
• Reminder improved
• Correction in Swedish calendar (writing mistake of Sunday)→ Region
Call and network management/GPRS Baseline improved for Type Approval
• • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • •
Improvement to page mode change handling on PCCCH cell.
Handling of GPRS connection mode change during active voice call.
Improvement to detach making in when needed mode if all PDP contexts deactivated during RAU.
Improvements of SI13 refresh.
Improvement of cell reselection using C2 parameters.
In NMO I when MS received Attach or RAU Reject with causes ‘MSC temporarily not reachable’, ‘Network failure’ or
‘Congestion’ MM state was incorrectly set as ‘NOT_UPDATED’.
Handling of reject causes #3 "Illegal MS" and #6 "Illegal ME" changed according to CR420.
PCS1900 GPRS uplink power level calculation used gamma_0 value of 33. That was an assumption from rel98 specs and is now
corrected to be 36 as stated in rel99 spec 05.08.
Modifications for PH to work correctly if some other SI than SI13 is received in TC=4.
In NMO I when combined Attach/RAU was ongoing and NW did not answer, MO call could be not available for a while.
Packet Uplink Assignment validity check corrected in case of Single Block Allocation and Packet Uplink Assignment with TA
index present.
Improvement of MO-call during LCS measurements.
Improvements of handling of long SMSs.
Improvement to cases where network sends Immediate Assignment Reject to CS call when TBF has been suspended.
Improvement of minimum QoS handling.
Further improvements of weak field functionality.
Improvement of functionality in case where detach and attach where send in same TBF.
Changed SMS memory available reporting to network. Now ME memory is always included.
Improved empty SMS handling.
Improvement of SMS validity check.
Improvement of dedicated mode establishment.
Incorrect parameter validation in calculation of full PSI schedule cycle resulted in valid parameter values being rejected and to a
failed cell reselection. This happened in case PSI_COUNT_HR = 0.
If serving cell became unsuitable because of RLA_P < HCS_THR but C32 value was still higher than for all neighbour cells, cell
was not changed.
Target cell SI was sometimes read from EXT-BCCH while it should have been read from BCCH and vice versa. This sometimes
caused unnecessary delay.
Improvement to case where SIM Toolkit application’s SIM refresh changes last registered network and MM restart is requested.
After SIM refresh was completed, the phone selected same network where it was registered prior to SIM refresh.
Improvement of Power Off Detach sending during active data transfer.
Improvement of flexible operator name indication.
Improvement of cell change during data transfer.
Improvement of GPRS attach/detach collision handling.
Changed page mode handling in case of downlink immediate assignment where IA Rest Octects are not present.
Improvement of GPRS detach procedure. Combined detach type is now always used when needed.
Improvement of PLMN search time and network refresh procedure.
Improvement of Extended Paging handling in non-DRX mode.
Improvement of manual network selection.
Improvements of Location Services.
Improvement of handling Routing Area Update Reject cause #14.
Improvements of Fixed Dialling Number feature.
MS does not anymore wait for DETACH ACCEPT if MT DETACH has a fatal cause.
Improvements of polling queue handling on MAC.
Improvements of MO/MT calls handling in idle mode with always online enabled after failed LA/RA
More stable behaviour due to Improved mobility handling
GPRS receiver performance improved due
-error correction for CS4 implementation
-internal DSP timing improved
AFC (Automatic Frequency Control) algorithm optimised
RX-performance improved by DC-offset compensation improvement
Improved interference measurement

CarKit
Improvement in mobility scenarios sees chap. Call and network management/GPRS improvement is especially seen when using a
phone in the CarKit
→ Operator and Car Industry
Improved speech quality when using HSU-1 in CarKit-91 (audio parameter optimised)
→ Region, especially Scandinavia
Messaging
SMS
• Receiving of multiple and concatenated SMSs improved
Miscellaneous Messaging
• Receiving of multiple voice notifications (Voice mail, fax, e-mail) improved
MIDPJava
• MIDLet execution improved


and many other things....