PDA

View Full Version : bf3 311 dead


jak2812
02-04-2003, 10:45 PM
hi, i have one 311 dead but if i read the phone it gives me right information.
can anybody helps me?, thanks
Alinus
03-04-2003, 07:16 AM
1st thing:

make a full back-up of your flash, using wray's 5.5

2. press back-ups option to save tech zone (original tech zone - without it your phone is dead)

3. u need a full flash for bf3 same version.
4. write that flash to phone.
5. after writeing that flash...do not dissconnect the phone and do not power it up....press patch firmaware option - select for your original tezc zone (the file is named after phone's imei), and wait for program to say done. press now "unlock" option"
6. after unlocking u need to power on the phone - first time without sim inside - after first time power on u can insert any sim


good luck
spectrum
03-04-2003, 01:51 PM
Very helpful hints!
I have been able to solve 3 of these
Many Thx
jak2812
13-04-2003, 07:23 PM
hi, after flash, is necesary to unlock?, thanks
Alinus
14-04-2003, 07:52 PM
just read again...what i had wrote before
jak2812
14-04-2003, 08:44 PM
yes i had wrote before but if i don't unlock, what happens?
thanks and sorry if this is a stupid question
REKIN_R.C.
14-04-2003, 08:55 PM
Can You help me ?
i need laguage for bf3 v104-KJ15A

please help
Thanks and regards
Alinus
15-04-2003, 07:34 AM
http://emexcomputers.narod.ru/

flashes and language packs
REKIN_R.C.
15-04-2003, 07:40 AM
I Know this page but there is only language for 103 version
and try downgread phone but phone after downgread doesn't start

REKIN R.C.
Alinus
15-04-2003, 08:48 AM
if the phone has latin language inside...to write complex language as russian u need to patch firmware....(of course with original tech zone)

bet free program to do it is wray 5.5 cracked..

instructions i had wrote them here on this alcatel forum many times...
jak2812
22-04-2003, 08:03 PM
today i have tried to make a copy with henrich and told me "1F80000-data of block corrupted"
what is this?
with henrich normaly i do a copy of the flash with the button "read fullflash"
a copy of the eprom with the button "read eprom"
and a copy of the teh with the button "read eprom" and marking the box R/W teh only, is this correct?
and finally when i press button "repair cheks" in wray55 it tell me
boot zone ok
flash driver zone ok
main code zone bad
fixed languaje zone ok
extended languaje zone ok
technical zone bad
static zone bad
patch Bbic zone ok
what is this?
i'll agree somebody answer to all the questions, thanks