do you know " error 0101" message of TERMINATOR V.2

[ant]

Hi,all forum.
please,do you know message error 0101 of Terminater

Thank.

[Blartiartfast]

been a while since i used it, but if the message comes up not allowing the program to start = dongle not found. If the program is running and it is when you try and connect, = phone not found. I'm fairly sure it is the latter

[ant]

When I connect the cable to phone,start the programm,a little blu
square.then appears"error 0101".I have noticed that if I don't
connect the cable to phone(T39)same error.

Best regards

[Blartiartfast]

Yep. Curiosity got the better of me last night, and I dug the dongle out for a quick fiddle (ooer). 0101 = can't connect to phone. sorry for earlier answer.

[adi]

Originally posted by ant
Hi,all forum.
please,do you know message error 0101 of Terminater

Thank.

If You still have same problem, I made this dongle and same error 0101 appeared when I tried to make any operation.I used crystal of 15 Mhz couse I cant find appropriate 14,7456 Mhz.So, I think that all problems with dongle became of wrong crystal.I dont know yet wich value for crystal Zou used so inform me about this.
Thanks

[kevinn13]

0101 means no communication with the phone.

Check cable and remeber home made dongles must connect via dongle and not serial

[superman]

remove battery for a short time and dry again