Help: Flashing Nokia 6310i went bad [Archive] - Nokia Flash Reverse Electronic Engineering

View Full Version : Help: Flashing Nokia 6310i went bad

ricobey

15-04-2003, 10:08 PM

Hi,

I was flashing the mcu of my nokia 6310i with the dct4 flash and kit from ucables.com and disconnected the phone while flashing by mistake...

Now the phone doesn't turn ON anymore and the software asks to turn the phone ON after pressing flash to flash....

Any suggestions and/or help would be greatly appreciated
Thanks

onimusha99

01-05-2003, 02:47 PM

What is dct-4 flasher are u using?

Try to change LPT setting in BIOS to 'ecp'

ricobey

02-05-2003, 01:54 AM

I was trying 5.22, but it seemed that the flasher files that I had were corrupted. I re-downloaded them again.

Nokia folks mentioned that the way the phone works is when a "change of state" happens. So when the flasher starts imaging the phone with the new flash, after you press YES, you just plug the power cable to it, this will create a "change of state" and the flasher will work.

Actually I was able to re-flash my phone with my original version 4.80 and I fixed the problem. It seems that 5.22 is for the European phones and since I have a North American phone, I need 5.20. Do you know where I can find that version?