Dct4 Error Message..i Need Help!!!

[shadow_t69]

HI, I HAVE THE DCT4 FLASHER, IT WORKS WITH 6510 AND 8310, BUT WHEN I TRY TO FLASH A 6310, I GET AN ERROR SAYING " AFTER START SIGNAL TX REMAINS LOW".....ANYONE KNOW WHAT THE PROBLEM...PLS REPLY...
NOTE: CABLE IS FINE...WHEN PHONE CONNECTED TO CABLE AND BATTERY, IT POWERS ON...

[SirLouBeng]

@ shadow_t69
did u try to place your phone in a higher place cause it says"....REMAINS LOW"??:D :D

[yeldar]

Check the ground pin on your connector.
if it dont work, replace connector and after that it should work 100%.
I have had that problems on some china flashers and only solution was repairing the ground pin, or changing the whole connector.

Also, dont have the cable too long, as this can also cause this problem!!