View Full Version : 8210 dead
oragraphic
28-04-2003, 11:52 AM
unlocked 8210 with dejan, think i used wrong start add, made a backup in nk flasher, how on earth do i restore, phone wont switch on.
aggro666
29-04-2003, 12:24 PM
you should erase the whole flash with knock22, and then flash a new backup to the phone
so the problem should be solved
oragraphic
29-04-2003, 07:53 PM
Thanks aggro, I will give it a go.
oragraphic
29-04-2003, 09:22 PM
hello aggro, thanks for u help, problem with knock, gives me error [cannot prepair phone] i am using lpt1, no problem with rollis but no fac to wipe whole flash with rollis. any advice would be greatfully accepted.
danwood76
29-04-2003, 09:47 PM
Rolis will erase the flash totally before it writes the new one!
Or should do!
Otherwise try dejan again, that what I used when I buggered up my phones flash!
oragraphic
30-04-2003, 07:04 PM
OK, erased flash using knock, now i need to find full flash, any idea's were i can find 5.27 full flash.
danwood76
01-05-2003, 07:15 AM
Goto http://www.freegsm.biz register with them (it's free) and then you will be able to go in the download section!
Clock on nokia mcu+ppm select your phone and version voila you have the software!
In the zip file there will be the mcu but there will be loads of different language packs, just choose the right one and use rolis to open the mcu+ppm and then flash it!
oragraphic
01-05-2003, 01:57 PM
hello danwood, done as you said, downloaded files but nothing resembles a full flash 5.27. just when you think your turning the corner.
danwood76
01-05-2003, 03:53 PM
Inside the ZIP you will find loads of files!
Look for a file like this: nsm3_5.270 - this is the MCU
Then one of the files with a letter on the end: nsm3_5.27a - this is language pack a
Find the lang pack you want (normally a) then using rollis load up the MCU and PPM seperatly by clicking on the 'Load MCU' and 'Load PPM' buttons!
You can then tell it to 'Flash' voila done!
If you want to convert it to a full flash click on the up arrow and then save it!
oragraphic
03-05-2003, 06:13 PM
thanks danwood, got a little further. now i have contact service when i turn phone on, what now.
aggro666
03-05-2003, 10:11 PM
just take "knock22" and make "quick set faid" , remove SP locks, and restore the imei, and maybe a FSR should be
and then the phone should work
oragraphic
04-05-2003, 09:30 AM
hello aggro, do i need a flasher cable (lpt1) or the com port type to quick set faid becouse when i try with flasher cable (lpt1) i get cannot execute, cannot analyze, cannot execute. again thanks for your help guys this bugger is driving me nuts.
aggro666
04-05-2003, 12:03 PM
to "quick set faid" you need a Data Cable, and the phone musst be switched on
oragraphic
04-05-2003, 01:52 PM
ok aggro, danwood, thanks for your help, i'll get a data cable and let you know how i get on.THANKYOU.
Powered by vBulletin® Version 4.2.0 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.