View Full Version : 8210 Contact Service, no MBus

30-04-2002, 11:20 AM
8210 contact service 5.26; don't let me use mbus interface (eeprom tools by cyberphreaks for example). I only can flash phone. Is there any program that can repair a file containing eeprom? Then i would be able o flashing the repaired one to the phone. Thanks in advance!

:: sunny ::
30-04-2002, 07:08 PM
you dont have Mbus cable or you dont want to used it ?:-? :-?

i think its necessary.


02-05-2002, 04:21 AM
try to use "apdate faid" after full flash with "Knock22"...

:: sunny ::
02-05-2002, 10:28 AM
@ag :
but how can he update faid without Mbus cable ??

02-05-2002, 10:36 AM
MBus interface doesn't work! Programs like eeprom tools or knok 22 tell me phone not conected (even nokiatool). Is there any program that repairs an eeprom dump? Thanks!

:: sunny ::
02-05-2002, 10:47 AM
did you tried eeprom tool by Dejan .. ?

if it also doesnt work try to clean your pinpoints on board..
i faced this problem and cleaned that pin points and it worked,,,


02-05-2002, 10:54 AM
nk_calc tells me Bad connection!
I think the phone has some bad hard. When i get it on, it hangs and don't let me even power off. Contacts aren't the problem. Thanks!

02-05-2002, 11:58 AM
If you have a mbus/fbus autoswitchable it doesn't work! :(
You need a mbus/fbus manual switchable! Buy one and it will work! If anyone knows how to convert an autoswitchable cable to only mbus i would apreciate!

02-05-2002, 04:04 PM
I've flasher kit with mbus adapter. The adapter works perfectly with the rest of nokias and those progs, so i thnik that's not the prob. Thanks!

02-05-2002, 05:00 PM
A normal mbus cable will work with all most any nokia progs! Logomanage, PClocals, etc... It WILL not work with NokTool1.7b by Rollis neither nk_calc by dejan! If it works with those program with other phones, then the problem must be in the phone! Else, your cable is not supported by noktool and nk_calc! i have an mbus fbus adapter to work with the flasher end's and it does´t work also with NokTool and nk_calc! I have to build a new one based on dejan's mbus scheme! :(


:: sunny ::
02-05-2002, 09:21 PM
- eeprom tool 3.0 / 3.1 works on autometic ,manual and pure Mbus interfaces

- Nk_Calc by dejan/- NokTool1.7b by Rollis works on pure Mbus and manual Mbus/Fbus(in which there is switch for Mbus and Fbus) interfaces.

thats wot i have tried and work 100%to me ...