View Full Version : From Mbus/Fbus autoswitching to pure Mbus?
Tagscan
17-05-2003, 03:05 PM
Hi People!
I read a few posts about converting you Mbus/Bus autoswitching to a pure Mbus..
I screwed open mij cable and found 3 wires, but what do i have to do next?
Who can help me with this?
Thank in advance!
Alex
otacon_remo
20-05-2003, 10:16 PM
simple!!!
black is for ground while blue and white are shorted to become the m-bus... the blue one is for fbus tx and white is for the fbus rx...
bwahahahaha...............:D
liteFun
21-05-2003, 12:37 AM
very funny.
if there's 3 wires, it's only FBUS.
there should be 4 wires if autoswitching, GND, MBUS, FBUS RX, FBUS TX.
@Litefun
there should be 4 wires if autoswitching, GND, MBUS, FBUS RX, FBUS TX.
Does that mean by covering the FBUS RX and FBUS TX pins you have a pure MBus cable, since you have the GND and Mbus only?
Cheers
Bob
P.S. I still don't see the need for a pure Mbus cable, autoswitching cables work fine for unlocking, what do you need them for? FAID? 3310 --> 3315? :)
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.