PDA

View Full Version : Be 4 138 00



ByteMe
16-05-2002, 12:04 AM
Hi!

I have this Alcatel above mentioned and i would like to know wich soft should i use to unlock it.

I've tried some, but i can't conect to phone.

plz help.
Thank you.
ByteMe.

Visar Mato
16-05-2002, 07:08 AM
If you tried softs and say phone no conected you need to check cable or pin's at the phone {clean the pin's) maybe they are dirty
I have unlock many times but sometimes {i don't remember what phones} v 138 you need to flash it again.
Find Eraser 438 cracked by Guar and Gsm boy flasher
Regards
Visar

Zzzooommm
16-05-2002, 11:03 AM
Check your cable, then try with this tested software:

All BE4 (http://www.mcomm.info/download/allbe4.zip)

:cool:

ByteMe
16-05-2002, 10:15 PM
Thank You.

I'll try it!

ByteMe
25-05-2002, 01:34 AM
Hello!

the problem:

when the soft tries to connect to phone (with phone off), it turns on the phone and reports an error. if the phone is on, it just reports error.

should the phone be on or off?


thanks.

srtech
16-06-2002, 08:20 PM
hi : ByteMe
i suffer your mail.ok you try below.use 5V external to pin 4 of connector (side to phone) then connect again .don't press any key on phone .it work by auto.this work without battery

ByteMe
16-06-2002, 09:46 PM
Hi!

can u explain better? i can't understand how to do exactly:(

thanks.
regards.

srtech
18-06-2002, 10:15 PM
see in blue frame.U must be remove connector shell then add +5V EXT to pin 4 of connector and - of 5V EXT to pin 2 of connector

ByteMe
21-06-2002, 03:51 PM
1 + question:

How did u get the 5v power? (what did u use?)

thanks.

srtech
22-06-2002, 12:27 PM
to ByteMe
for me use +5V from my PC(ho ho ho ...joke) .you can use 4.8V from battery (1.2*4=4.8v)instead 5V.if you can make cable by your self it will work without 5V EXT

ByteMe
25-06-2002, 12:35 AM
the cable i have, i bought it, factory made, so it should work without problems. but, i have the problem mentioned above. is there a particular reason for that? or it happens with most cables?
does it happen with home made cables too?

@srtech

in ur scheme, u use 5v power too, but u r saying it's not needed?

batteries with 1.2v, i only know that some reachargeable batteries have 1.2v. is that this case?

the phone battery is 3.6v, + a 1.5v battery works too?

regards.

srtech
25-06-2002, 12:45 PM
ok ByteMe.at first i have problem too
i'll tell your step by step

cable made by factory design for small thay use capacitor about 0.1UF
if use capasitor 10 UF it not needed 5V EXT

battery 1.2 get serial 4 cell must be 4.8V when full chande willbe 5V-5.5V

for 3.6+1.5 can use no problem

****everything i said test by me ****
sorry i'm little for english

ByteMe
26-06-2002, 12:14 AM
Ok.

that's clear enough.

thanks:D