what is the solution for water damaged phone and the grounded

[ema2000]

guyz can anyone tell me what is the solution for that
i've 3310 fall in water and then cleaned and dryied the phone now when i put the battery the phone leds gets on and speaker made noises , i tried many many times to flash the phone but no success :confused:
tell me what to do plz :(

[danwood76]

Soak the phone in methelated spirits for half an hour, then get a tooth brush and some fairy washing up liquid, put the washing up liquid in a bowl with some water and scrub both sides of the board for about 10 mins per side!
Then rinse under a cold tap!
Use a hair dryer highest heat setting lowest blow power and go up and down each side, then leave the hair dryer blowing over the top of the pcb for about 5-10 mins!

This will remove any corrosion and dirt on the pcb and will hopefully fix the problem!
You may need to do a reflash, try one from a working phone!

[robphp]

Do as danwood says,but you can also use isopropanol to clean the pcb as well.This has a good success rate for me.You can buy it from any pharmacy.
Regards.
Rob

[ema2000]

i'll give it a try :confused:

[ema2000]

hey guyz it worked , wow iam very greatful thanks to both of u :D

[chunkhead]

It's the meths that did all the work! It's better to get some isopropenol, because you can also use it to fine clean the pcb with a cotton bud as opposed to dipping the whole board! I also use the liquid that comes with vcr\cd\fdd cleaning tapes! This stuff is great for cleaning the contacts!!!;)