View Full Version : Dead 8210 Due To Wrong Start And End Address

29-05-2002, 07:27 PM
I followed instructions regarding the 6210 no signal problem but used it on an 8210v5.25. The problem is I shouldn't have used the solution to solve the 8210 no signal problem now I have loaded the flashed I save from ppmmanager091 by from_Vanoff, not knowing its strictly for 6210. When I loaded the flash file back to the phone the flash address went from 00200000-00600000 instead of from 00200000-00400000. Please help me what do I do, my phone is dead. PLEAAAAAAASE Hhhheeelp me.

29-05-2002, 07:47 PM
Simple, just get a full flash 200000-400000 and flash it back to your phone. When finish flashing, use Eepromtools to update FAID/Unlock.

29-05-2002, 08:14 PM
Thanks, Kid

Where do I get the full flashfile for 8210v5.25 I have tried every site but no success please help, I really do appreciate your help. thanks in advance

29-05-2002, 09:30 PM
To get a full flash, it's safer to read it from another working phone, coz it'll work 100%. If you have another 8210, even if it's not the same version as your original, it's ok.

If you don't have another set, you can try getting the mcu+ppm(200000-3D0000) from
You can select english version from the bottom of the page.
Register is free.
You should get the "C" pack of the MCU+PPM for your language if I'm not wrong.
*this is not the full flash! ONLY 200000-3D0000!

then, get the virgin EEprom (3D0000-400000).
*you can get this from my www

When you have all the flash, use Rolis DCT-3 Flasher(preferred) with a LPT Flasher cable and flash the MCU+PPM FILE(200000-3D0000) into your phone.

Next, is the eeprom.
Flash the Virgin EEprom3D0000-400000) into your phone with the flasher cable....

Ok, when the above is all done, use eepromtools with a M/bus cable to repair your IMEI by using the manual function, input your IMEI number and your IMEI should be fix. Next, click the lock to remove the SIM-locks. (1 click job:cool: ) ) And finally:D, still using the EEpromtoolsV3.01, click on the 1st button (Update Authority ID).

Your phone should be back to a full working state.:D

In future, always make a FULL BACK UP of your original flash before touching it.

30-05-2002, 08:33 PM
Thanks alot men, my phone is working now but there is still no signal what do I do to make it have signal, I know its not a hardware problem. Thanks in advance

30-05-2002, 08:41 PM
What is the actual cause of your NO NETWORK?
Is it after flashing or before flashing?

30-05-2002, 10:42 PM
Before flashing there was no network and after I flash it there is still no network, why? If its hardware, I have checked everything to the best of my knowledge and its all fine, so i don't think its hardware.

Thanks alot, I really do appreciate yur help

31-05-2002, 06:14 PM

Thanks alot Kid, my phone is working 100% now, it was actually hardware problem, the antenna wasn't touching the board properly, so I forced and its working, once again, I really do appreciate your help
::D :grin: :-D