userport question

[jenkins]

i have installed the userport.sys i need to know what settings i need to put into userport?

here's my LPT1 port settings:

I/O range 0278 - 027F
I/O range 0678 - 067F
DMA 03

thanks for any help

[chunkhead]

Just match the settings to userport! It's normally the top one! So in your case, 0278 - 027F!;)

[sergo_zmeia]

Do as chunkhead said /regards my friend/ buut it is better to maintanece your phone under win 98 SE.;.
Regards!
Sergo_Zmeia

[jenkins]

Originally posted by chunkhead
Just match the settings to userport! It's normally the top one! So in your case, 0278 - 027F!;)

i done that, i think it's working.

when i use nokia flasher (by rollis)4.79 i get an error message saying:

power off mobile then connect
(or cheak cable : phone tx = low(0)expected but phone tx = high read)

i tried it with the phone off and that didn't work

[jenkins]

Originally posted by sergo_zmeia
Do as chunkhead said /regards my friend/ buut it is better to maintanece your phone under win 98 SE.;.
Regards!
Sergo_Zmeia

i intend to install win98SE on a duel boot with XP, i have to wait untill i get broadband so i can download it:D

[chunkhead]

Are you using a 3210? These phone power themselves on when connected to cable! If not, clean your battery connector and cables, power on phone whilst connected, then power it off! This should now allow you to flash! When it asks for "Power on phone", plug in a charger!;)