8210 flashing prob

[spida_singh]

hi,had n 8210,working perfect,all it is,i wanna upgrade 2 5.31 as it is 5.28,ive tried using rolis,knok,but no luck

all i get it tx high,check cables etc,tried other phones,cables are fine

wot cud b rong wiv it,i ad a similar problem b4,then i used a flasher by cyberdog i thnk,n it worked ok,has n e 1 got a link 2 that prog,or is there another way i can get the flash on2 the fone,reason i wanted 2 flash is,i get signal,but it then drops after a few seconds,it isn hardware,ive changed imei etc usin jordik 3.21

n e other ideas?

cheers

spida!:D

[sergo_zmeia]

Try to clean the contacts on the phone PCB ..... for no network try chunkheads knok metod, or run a test with Eeprom tools 4.0 to get a point where to start..
Good luck!
Regards!
Sergo_Zmeia

[chunkhead]

8xxx series phones, the connector must "Click"! Remove the foam padding if any and also lower the two screws next to the pins to about 3\4 of a millimeter!;)