PDA

View Full Version : 2110 led's



SmOg
25-09-2003, 10:48 AM
I want to change the leds into red, or ice blue, but if i insert 4 or more the light of these are getting lower and lower! What led type should i use without brightness loosing? (voltage, capacity...etc.) ?

Thank you!

danwood76
30-09-2003, 06:58 PM
To increase the brightness in the LED's find the resistor that is wired in series with the LED's just bypass this with some solder or a bit of wire.
I'm not sure where it is located on the nokia 2110 but on the 3310 it is at the top of the board next to the other resistors!

There should be two, one for the screen LED's and one for the Keypad!

If you can post a photo of the topside of the board I may be able to highlight them for you!

sergo_zmeia
01-10-2003, 11:35 AM
Dont just shortcut the resistor..replace it with one with smaler resistance...this is safer..
Regards!
Sergo_Zmeia

SmOg
01-10-2003, 09:05 PM
Thx for your kindly help! I will post photo as soon as i can!

deadspot
03-10-2003, 04:30 PM
if you short the limiting resistor the bad effect is your battery easily drain....