DCT3 (Com1) programs for WinXP.

[dmac]

Guys iv installed WinXP.

My applications for DCT3 phones dont work with the data cable unless for Logomanager.

Any programs for reading out data and modifing, like EEPROM Tools, nokia tools, etc... dont connect to the phone. the execute ok, but none of them connect via the serial port. it works fine on the Win98.

There is UserPort for using the Flashing cable, but thats for the LPT port.

- Is there any simillar software for that will work for this problem.

Please get back to me if you know anything...

Thank you!

Darren.

[sirpaul1]

I don't know if you've not used userport properly but I run Noktools 1.8 on winXP. Have you tried disabling then reenabling the com port. I had a little problem a while ago where i had to do this everytime i used the com port.

[newcasper]

nokia tools 3.21 works fine with me
but 3.25 working but not all the time with me
eeprom tools not working at all with me

when I use winxp pro

[dr.bizar]

Hi all.

Did you all remember to set "win98 emulation enabled" (or WTF it's called)
under properties of the given .exe file ?

If you want to read more about the com port restrictions and
pre defined settings in WinXp/2K
Plz see the "All the Basics" guide under "tutorials" on my site
(Just scroll to the bottom)

http://blight.dk/nokia/tutorial/basic.php