View Full Version : Nokia 5210 help needed
saxosteve
18-08-2002, 05:16 PM
Hi, im going to be unlocking my 5210 when the cable arrives. Can anyone reccomend any good software to use (with serial cable)??
Also is ther a way of backing up the phone incase it all goes wrong??
Thanks
Mehvishal
18-08-2002, 08:53 PM
Jordik 3.21 or EEPROM Tool 3.1
Both working 10000000%%%%%%%%
Squirt1000
18-08-2002, 10:18 PM
So im right in thinking that a 5210 is a DCT3 nokia then?? :confused:
User32
18-08-2002, 11:42 PM
I'm using knok-phoenix.
@Squirt1000: Of course it's a DCT3.
Juan2k
19-08-2002, 04:31 AM
Yes DCT3 but have you edited and flash it and get signal afterwards. DCT3 with security checksum i think
Squirt1000
19-08-2002, 12:10 PM
Ahh, me not doing anything with mine then!! :p
User32
19-08-2002, 12:42 PM
I don't have a 5210, so i can't test it.
cprafferty
21-08-2002, 10:10 PM
@Juan2k
Err WHY ARE YOU STILL FLASHNG DCT-3's
for a safe no worry unlock of you 5210 follow this info
Get MBUS datacable for 5210( 8210 connector)
copy of nokia tool by rolis version 1.8
open phone, remove SIM card and connect datacable
plug datacable in to PC
turn phone on
open Nokia Tool by Rolis
click read
click open all
click clear SP locks
close nokia tool by rolis
turn off phone
disconnect datacable form PC and phone insert Sim
one unlock 5210
Squirt1000
21-08-2002, 10:14 PM
So is it ok to try and use Eeprom tools 3.1 or will that cause problems??
cprafferty
21-08-2002, 11:01 PM
Yes EEPROMS tools is fine also
User32
21-08-2002, 11:38 PM
I use knok-phoenix for unlocking (and updating faid after flashing).
Juan2k
22-08-2002, 12:19 PM
im not into opening locks its editing 5210 and getting signal afterward. opening dct3 phone is not the issue its editing ya no
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.