If flashing doesn't help...

[MobileKiller :>]

Hi Everyone!
I just screw up a 3410 (with a stupid unlocking software i think)
Rolis and Knok say that:
-Phone Ram is bad

I'm not able to read, write or do anything with the phone, although the progs
recognise connection, (but cannot initialise bootstrap)
Knok says: Cannot prepare phone (when i just pressed ON)

I know that imei and phone code is wrong.
I can't turn on phone :-?
Please Help

Regards

[asgaardro]

chk u're flash cable and the contacts from phone
uhen u connect the phone to flash cable u should hear a short beep(or not)[to my the phone is give a beep]
try to flash only with knok95 buid 1 because is verry good
if the phone isn't recognize try to erase the hole flash and write it again this should work at any time

[danwood76]

Reheat phone RAM chip if you can!

Use Chunkheads cleaning technique to clean whole board and reheat with hairdryer!

[chunkhead]

Persistence is the key here! Using Rolis, change the delay settings to 3, I have the best results here and keep trying to flash it! It will flash! Try other delay settings also! Just keep trying! ;)