vrepair
26-01-2004, 09:47 AM
after full flashing with griffin the phone did not do the full factory set the result is the phone is dead pls help
cjard
30-01-2004, 12:47 PM
full flash? with eeprom too?
what address did you start flashing from, what address did flashing end at?
If the phone will accept another flash, then flash it again, but with a different version of the software. I have a few versions of 3310MCU, with PPM C (English/French/German etc)
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.