PDA

View Full Version : nse-2 contact service


mobilehelp
03-09-2002, 02:45 PM
greetings!

there are times when i unlock this unit i get a contact service. i there any other way to repair this other than replacing the eeprom ic?

br
ian
Jeric
26-09-2002, 04:33 PM
Use Nokia Tools of Jordik 100% no contact service
KodeX
27-09-2002, 07:55 AM
No need to replace eeprom if CS is caused by wrong unlock of NSE-2 (5110i).

You can repair it with knok. Just click on Modify locks and select MCC+MNC. Choose Open then click OK button. CS is gone but locks are all closed. Don't worry, just unlock the phone with partial flash and everything will be fine. It's 100% working. Tested by me.
mobilehelp
18-10-2002, 10:32 AM
@jeric
no joy with jordik, pre.

@codex
fixed the contact service but all locks are closed. tried unlocking with partial but no joy. i think it partial unlocking will not work on mine because the closed locks are like (remember the old days) flashing a 3310 with a different eeprom. could you elaborate on what you did with yours? thanks

br
ian
Alinus
21-10-2002, 10:11 AM
why unlock with partials?
use nc_calc by dejan
or eeprom tools by phreaks
mobilehelp
22-10-2002, 10:42 AM
@alinus

no luck there. after unlocking, phone returns to Contact Service again.

i'm still open to suggestions.

br
ian
Alinus
22-10-2002, 11:06 AM
u do not unlock it.
u repair contact service....
use nc. calc by dejan... press f2...
if is not working - upload mcu+ppm then update faid...
if is not working - is hardware...
mobilehelp
24-10-2002, 06:51 AM
@alinus

no luck it nk_calc. it's not hardware coz when i replaced the eeprom, the phone is ok. also flashed new mcu/ppm.

btw, have you encountered this problem before? where you able to repair the phone using your suggested solution?

br
ian
comet2
27-10-2002, 07:08 AM
@mobilehelp

1. follow Instructions of KodeX it works 100%,
2. partial flashing used Rolis 477 select 5110i-nse2, click unlock(use flasher cable)
3. return to knok modify lock, Modify MCC+MNC, modify set-up, close,Modify value, enter FFFFF(5) ok
4. Phone setting, reset (if will not reset just "ON"ur anr repeat 3 & 4) it works by me 100%
mobilehelp
28-10-2002, 10:19 AM
@comet2

thanks, pre. i'll try it again.

br
ian