View Full Version : 8850 with Strong Bar Signal
bongvil
22-02-2004, 01:45 PM
:-?
Hi,
Is there any body who could help me to locate the problem of 8850 which has strong bar signal but whenever I make a call it could not make any contact and also if I send a message to somebody message failed error appear. I have already checked it with Eprom test 4.0 and there is nothing wrong with it, already upgrade its software and update FAID still failed to make a call and send any message.
Thanks in advanced,
bong :-?
danwood76
23-02-2004, 02:35 PM
Have you tried chaning its IMEI??
try this first before anything else
Also couple be a hardware problem can't remember what it is though
Its a long time since I messed with any hardware :sad:
regards,
Danny
bongvil
23-02-2004, 03:54 PM
:)
HI danwood76,
Would you mind if I asked where I will I get the IMEI, cause I'm using its, original IMEI. Can I used the IMEI of other cellphone unit?
Thanks,
bong :smile:
danwood76
23-02-2004, 06:25 PM
Just try an IMEI out of another phone to see if it works
Changing the IMEI is illegal in many countriesn so be careful ;)
regards,
Danny
markchee
24-02-2004, 09:53 AM
Frist change to a new PA.
See sign of any damage on antt. switch,or reflow the Haggar.
If Tx & Rx stays for short time,is time to replace Hagar.
Post result for people to learn,thank you
deadspot
24-02-2004, 10:11 AM
i have same problem w/ 3310.....so i replaced RF amp......its ok right now...
FYI
iecep
12-06-2004, 11:58 AM
try to check the message setting menu of your phone for the messages sent as-it must be as text,for texting error.since you have full signal indicator and you cant make a call,change the 32khz crytal oscillator of your phone ccont.this will, i hope solve your problem.I had a previous case like yours on my repairshop. :smile:
regards
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.