View Full Version : Flasher cable question
NokiaFlashUser
28-03-2004, 10:16 PM
I was wondering this schematic i was thinking of making is it possible to make it without putting it on a board sorry for the stupid questions!!
The 1 i bought from tele-west worked once and packed in dead as a dodo, it was pretty cheap quality only payed a fiver so not really lost out.
Cheers in advance :rolleyes:
danwood76
29-03-2004, 12:00 AM
You could put it onto strip board,
It is easier than PCB and a lot better than just wires ;)
Basically its a circuit board with lots of regular holes on it with copper tracks running all the way along in one directing
To break tracks just use a drill bit of an adequate size
regards,
Danny
NokiaFlashUser
29-03-2004, 12:06 AM
Where do i solder the ground points to this has been really bugging me as im making 1 tomorrow maplins has all the parts for 75p LOL
Thanx :smile:
danwood76
29-03-2004, 12:10 AM
All ground points go to pin 25 on LTP
Yes the parts are very cheap ;)
regards,
Danny
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.