atr 5.3 99% error03

[netroid]

i tried upgrade t10 to t18 and had subject, after it phone not power on, i have t10 00W12 and flashed with in990723, and with other flashes, but all time i had subj. help plz.

[Alinus]

error 03 means low battery - have full battery charged.
and after that u might change flash if this is not working.

[Visar Mato]

Try with Ericsson tools 2Kay is the best for this.
Regards

[netroid]

okay, i'll try it (downloaded from www.mobile-support.org),
2 Alinus: i had fully charged bat, and ext. power in 12 pin.

[KodeX]

Old NE-Tool works fine on flashing and reviving dead eric t1x too.

[Alinus]

then probably was the flasher, as visar mato said. i too had errors with zulea's soft in writing.
but worked after 2 or 3 tries.
use 2 kay. or NE tools, or varanius.
good luck:D

here in romania there is a word: as there can be no woman that can't be "done", there no phone that can't be done also:D:D:D:D:D
hope i'll not get an yellow card for this:D

[netroid]

2 kay v2.4 halt on Blancking .... 2 kay v 2.3 don't detect my t10.
And else i read solution from er2000 and already have t10 with "Insert correct card", reset in ne-tool didn't help.
i'll try with varanius....

[netroid]

may somebody give url with working flash in990723.r2a?
mprobably i have bad.
Reading flash from working t10 (same version 00W12), and flash to dead didn't help.

[netroid]

Big THANKS to all who helped me.
Finaly after trying many flashes and flashers i look at my cable. There was a connect from 12 pin to 5&6. I cut it and all worked. I liked varanius because it one of all soft writes quickly eeprom, upgrade to t18 but didn't find differents. Can somebody tell me?