PDA

View Full Version : S55 unlock problems with Freia F9



Pooya
21-05-2004, 07:35 AM
Hi,

Trying to Unlock with Freia F9 (downloaded from this site)
Using Data Cable on Serial COM1 (verified connection due to use with Datasuite) Data Cable came with Phone as part of set with Camera

I get the following:
COMM_LoadBoots : selected phone family is 9
COMM_IsBootRunning : bootcode does not seem to be running
COMM_LoadBoots : Waiting to power on the phone ...
COMM_LoadBoots : phone is not powered on

My steps were:
1. Remove SIM Card from phone and power off phone
2. Connect Cable to PC and Phone
3. Start Freia and Select Read Flash from Phone >> Firmware >> OK
4. Get no response : phone is not powered on (see above)

Thank you for any help

AleXmaN
21-05-2004, 12:24 PM
It's Original cable ;)
U need cable with internal power suply, but u still make it by yoyr self.

Connect the
pin 1 to charge +5 V
& the 2-nd to the GND.
for this.

U can find this power on it's charger

be careful!
Don't mix up GND this (+) you phone will not charge at all.

Good luck!

Pooya
21-05-2004, 10:08 PM
Thank you, but which pin is pin 1 and which is pin 2, and similiarly which is power and ground on the charger?

AleXmaN
25-05-2004, 03:17 PM
http://forum.allsiemens.com/files/x55_siemens.gif

See here

VAB1981
10-06-2004, 01:36 AM
WHERN FREIA SAYS "WAITING TO POWER ON PHONE" PRESS ONCE THE POWER BUTTON.

:lol: :lol: :lol:

AleXmaN
10-06-2004, 12:43 PM
Using Data Cable on Serial COM1 (verified connection due to use with Datasuite) Data Cable came with Phone as part of set with Camera

to VAB1981:
Try to do it with Original cable, or try to learn English first :-P

Good luck!!!!
;)