PDA

View Full Version : dead 7110....help appreciated



durius
18-09-2002, 10:47 AM
Hello,

I have a dead 7110 and have tried to flash the backup I made previously (using Rolis 478).
But in the middle of the process I get a message :
Flash erasing error check.
Must receive 91 00 FF but received: 00 00 00
Check Vpp, Vbat voltage, phone type.

Can any of you guys help and give some instructions about recovering the phone...
Also when I try to use knok I always get a message: cannot prepare phone...
What kind of cable should I use with knok...?

Thanks a lot for your help and keep up the great work


durius

durius
19-09-2002, 04:06 AM
I have managed to get the phone working but it keeps going on and off...
I have checked the ppm+mcu with Rolis 478 and it gives this message:

Flash V 05.01.08-12-00.NSE-5.(c) NMP. scan results
------------------------------------------------------
MCU SW CHK test ............................ Ok.
Impossible to find PPM begin
Tune EEPROM test ........................... Too less flash dump.
Security EEPROM test ....................... Too less flash dump.
------------------------------------------------------

I have tried to correct the flash with ppm manager but it keeps the same error.
Eeprom tools says: Can't read ppm version.
How can I solve this.
thanks for helping

durius

Visar Mato
19-09-2002, 07:35 AM
You need a mcu ppm ee flash go at www.gengheraenga.net
clear sp lock,update faid
and EnJoY