altaf
03-11-2004, 10:32 PM
Hello Friends,
Today, I have received an 8310, totally dead. It has voltage 3.7 volts
at battery connector when charger is applied. I tried to connect it to
UFS 3, but when I click on check, it says 1st boot error...
Now, I would like help from u people, about how to go about checking
this phone....Please....step by step instructions.....not answers
like check the service manual...etc, because for my last few questions,
I have received such answers. Fact is I really do not know how to follow
a service manual.....like when it says check vsin 3.8 v or vcore at
c209(example) 3.8 v....I mean, if I connect a 3.6 volt to the board,
should I place both ends of the multimeter at c209, or one point at
positive of battery and other at c209?????
Also, do I need a test jig even to measure voltages, or I can just
connect a 3310 battery with jumper wires to +ve and -ve points of the
board,,or is it necessary to have a jig for all models.
These questions may sound foolish or even stupid, but I do have
to start somewhere, and I need ur help! come on people help me start off!
This is a sincere request!
PLEASE!!!!!! HELP me with this phone....
Regards,
Altaf
Today, I have received an 8310, totally dead. It has voltage 3.7 volts
at battery connector when charger is applied. I tried to connect it to
UFS 3, but when I click on check, it says 1st boot error...
Now, I would like help from u people, about how to go about checking
this phone....Please....step by step instructions.....not answers
like check the service manual...etc, because for my last few questions,
I have received such answers. Fact is I really do not know how to follow
a service manual.....like when it says check vsin 3.8 v or vcore at
c209(example) 3.8 v....I mean, if I connect a 3.6 volt to the board,
should I place both ends of the multimeter at c209, or one point at
positive of battery and other at c209?????
Also, do I need a test jig even to measure voltages, or I can just
connect a 3310 battery with jumper wires to +ve and -ve points of the
board,,or is it necessary to have a jig for all models.
These questions may sound foolish or even stupid, but I do have
to start somewhere, and I need ur help! come on people help me start off!
This is a sincere request!
PLEASE!!!!!! HELP me with this phone....
Regards,
Altaf