PDA

View Full Version : moto evolution multi clip



wolfecom
17-04-2005, 08:52 PM
does anyone or has anyone got the instructions for imei repair using this clip

Alinus
20-04-2005, 06:37 AM
for what phones u want to make imei repair?

wolfecom
27-04-2005, 10:09 AM
i want to make imei repair to v50 and 720 thanks m8

wolfecom
27-04-2005, 10:12 AM
alinus can you tell me if this clip will remove tamper alert from the v50 as ive got 5 in tamper alert if so please tell me how to proceed to do it thanks wolfe

Alinus
28-04-2005, 06:19 AM
friend,
the procedure to identify a V 13 or V 14 phone is as follows:

swtich the clip in V 13 possition ( this means that the switch for V 13, V 14 must be on the left site of the clip and at this moment blue led must be on even if phone is not connected).


connect phone to box using propper cable.
power on phone without sim inside.
blue led must blonk several times.
when blue led is stable pres *#06#
if imei is 0000000000000 then u have V 13 or lower phone.
if imei is as on the back of the phone (does no change) then is v 14 phone.


if phone is V 13 or lower procedure for unlocking is this:

clip in V 13 mode ( blue led must be on even if phone not connected)
insert sim card in phone.
power on phone when connected to clip.
when phone asks for special code then insert 00000000 and * on the key pad.
phone will say "completed"
then power off phone quiqly, disconnect it from clip.
remove battery
start phoen iwthous sim inside once
insert sim and check if unlocked.

ATTENTION !!!
procedure for unlovking V 13 works only if phone displays:
"enter special code"
or
"enter NOW special code"

if phone displays "Tamper Alert" or "Wating to enter special code" before unlocking follow this procedure:
connect phone to clip without sim inside (clip in v 13 mode). keep red button pressed and power on phone.
blue led will light 2-3 times and clip will poer off the phone automaticaly.
chech with sim inside if phone is in right status for unlock and unlock it as described above.
if not, repeat the procedure until it is.



if u have V 14 motorola phone.
switch clip in V 14 mode. blue led is off when phone is not connected.

check if phone displays "enter now special code". if so follow this procedure:
connect phone to clip, sim card inside.
blue led will blink several times.
(if new firmware is aknoledgegd then clip will try lear it. this may take 20-30 minutes)
when blue led is stable press red button.
phone will enter test mode and blue led will blink.
then phone is unlocked.
press #01 on the phone to exit test mode.


ATTENTION:
if V 14 phone is in Tamper alert mode or dismplays "wait for enter special code". connect phone to clip in V 14 mode with sim inside.
blue led will start blinking several times and then remains stable.
leave the phone connected to clip until phone will display "enter now special code". then press red button. phone unlocked.

(if phone is in tamper alert close the flip to avoid the sound...)



good luck !
if any other instructions are required feel free to write us on [email protected]

wolfecom
28-04-2005, 09:21 PM
thanks for the help alinus
imei now repaired and a couple of v50 s are now out of tamper alert
thanks again m8 your a true gent

Jwpara
16-05-2005, 07:46 PM
Alinus I give u a beer for this complet and perfect answer ! :-P

b.r.