5210 No Signal After Flashing

[SmaRkieS]

I made my own moded flash 5210 using its FUBU flash. I simply replace there old ring tones with new Ringtones using PPMEDIT After flashing the phone... Turn on then 2 sec with signal after that no more signal.. I done Update FAID, and unlock the phone. Reset to factory defaults, restore original IMEI.. still not working...

Then I have to restore the FUBU and it works back to its orignal..

Regards!

[NokDoc]

Hi,

Just checking, I hope U did use MCU&PPM file only?

FUBU (Full Backup) normally have the eeprom area in the file too, but many tools don't support modding such files.

When using only MCU&PPM files, there's also no need to do all this imei repair or unlock stuff.

NokDoc

[SmaRkieS]

Thank you so much its a big help. I also tried with 6210,6220,7110,8859 same as 5210 its hard to mode. But did some little modes and it works.

About the 5210 models I have found out that it has different version like
The Germany model has a Temperature detector and don't have the profile logo and the Finland model dont have a Temperature detector but it has a profile logo.... hmmmm... strange..

Any way thanks for the big help!! CHERRSSSSZZ!