View Full Version : 8210 led problem
thelaw
18-10-2002, 11:19 PM
Just got another faulty 8210...
Power amp had gone, so i have changed that and its working great now.
Problem is, the LEDs wont light. This phone was water damaged. I have cleaned it all down prior to installing the new PA.
I can get the LEDs to light if i ground a cathode (they light up orange instead of green). but i have reoldered all the LEDs with no luck of them actually working properly.
any help appreciated...
cheers,
jon
xiaye
19-10-2002, 04:09 AM
8210/8250/8850/8855 LED is driven by a IC
the IC provide the current, not voltage.
You can try to replace the IC.
Because of the PCB, 8210's LED only goes light when all of them are installed correctly, so, if one of them is damaged, no LED will work any more. Check your LED one by one.
slikmik
20-10-2002, 05:57 PM
Originally posted by xiaye
Because of the PCB, 8210's LED only goes light when all of them are installed correctly, so, if one of them is damaged, no LED will work any more. Check your LED one by one.
Sorry i disagree i have 8210 - old rom 5 with original v5.16
Soldered on leds in keypad - and they light even if i had only one led attached or 3 on one side and not on other, strange :p
Mike
Aaron
21-10-2002, 06:37 AM
Originally posted by thelaw
I can get the LEDs to light if i ground a cathode (they light up orange instead of green). but i have reoldered all the LEDs with no luck of them actually working properly.
How do you make them light up orange??
Rooster
25-10-2002, 03:53 PM
By applying too much current !
thelaw
25-10-2002, 05:00 PM
exactly :) you can ground one to test which has gone, but dont do it for more than a fraction of a second or you will blow them all.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.