flashing

[panicman]

hi doc,please help me ....im new to this and want to do a flash backup using rollis 4 my 3210 & 6210 .i have a flash cable in my lpt port on my laptop but im getting error msg.TX=low but expected TX = high.and when it says power on fone shortly do i have to wait till it says now? pls help im getting pissed.thanx

[catweasel]

panicman,

turn off your phone : connect to flasher cable : open Rolis : Read flash / Write flash : open flash file (if writing) : ok :- when it says power on shortly switch the phone on, don't wait or it will time out. if reading flash save it if it ok if not try again Using a laptop I find rolis gives me errors but if you persist it will work, try to make sure all contacts are good and also try when it says power on shortly plugging in your phone charger (it works for me). Good luck

[fyxnuuk]

maybe its the delay index:D



:D fyxnuuk

[slikmik]

:o maybe its parallel settings in bios - (ecp d=should be)

:o maybe its cos the laptop doesnt have as higher lpt voltage as a desktop machine

:o maybe try plugging laptop power in when flashing - does it work then?

:o maybe.... i can't think of any more ideas....

:p good luck dude
Mike

[becube]

is it possible to flash a 3210 phone using only Tx,Rx,Mbus and Gnd? without the Vpp and Btemp..... coz i got only the 4-pin 3210 data cable on my flasher interface.... other phones dont need Vpp and Btemp...
pls email me at [email protected] for your response..
thank you...