Rolis nokia Tool 1.5b

[Doc]

Hi!

Has anybody got Rolis' Nokia Tools to write any data?
I want to write EEPROM to a 6130 without any check before (I know it's good). But Rolis Nokia Tools does not allow to write anything and Rolis 5.14 says: Bad CHK check File/model.

Is there any prog that just writes hole (external)EEPROM to phone?

Thx

Doc

[Abe]

yes.... nokiasp.....
www.gsmsoftware.host.sk

but you cannot write eeprom security bits (example to open all 4locks when are closed...etc)
that you can do only with ponyprog......
use this schematics....
easoiest schematic to make......
Below is the worlds most simple EEPROM programmer for 24Cxx
with Pony Prog. No components needed, just wires and a
DB-9 Female Connector.

COM Port PIN3 -------------Connect to-----> EEPROM PIN8(VC)
COM Port PIN4+PIN8 -------Connect to-----> EEPROM PIN5(SDA)
COM Port PIN5 -------------Connect to-----> EEPROM PIN4(GND)
COM Port PIN7 -------------Connect to-----> EEPROM PIN8(SCL)


Configure Pony Prog Hardware to:

Serial
SI Prog API

or

Serial
S/I Prog I/O

[Gianni]

Dear Abe,

I have tried your solution to read the eeprom of mine 6110, but it doesn't work, so i have tried to read it with ponyprog and multipipo programmer and it work fine 100%....

i don't know why, but your suggestion don't work for me....

BR

Gianni.

[Abe]

Use this pins and pony prog....not nokiasp......
This scheme is simplified jdm programmer..........

[Gianni]

i do it.... but it doesn't work for me.....

BR
Gianni.