dead ufs tornado box

[neilthirumuttam]

is there any body who can help me to repair the dead ufs3 box
Its processor is ok (tested on other box). problem on the PCB
when trying to connect " devise not found" is the message!!!

[THE FOX]

Did you try using another USB cable?

ALSO

Check to see if the board has dry joints in the solder?

Just use a soldering iron and reflow all the points...

GOOD LUCK... :o :o :o

[bojs]

is there any body who can help me to repair the dead ufs3 box
Its processor is ok (tested on other box). problem on the PCB
when trying to connect " devise not found" is the message!!!


I used to have this problem with my tornado. I just replaced the FT232 IC and then it's okey.

Hope this will help.


br,
bojs

[neilthirumuttam]

Did you try using another USB cable?

ALSO

Check to see if the board has dry joints in the solder?

Just use a soldering iron and reflow all the points...

GOOD LUCK... :o :o :o


DRIED ALLPARTS ON THE MAIN BRD
TESTED WITH ANOTHER BORD
PROCESSOR IS OK
TESTED THE TRANSISTORS DIODS REPLACED CRISTEL

I THINK IT S SW PROB
LET ME KNOW THE SW TOOLS TO READ AND RITE THE BOX