View Full Version : dead ufs tornado box
neilthirumuttam
16-10-2005, 04:38 AM
is there any body who can help me to repair the dead ufs3 box
Its processor is ok (tested on other box). problem on the PCB
when trying to connect " devise not found" is the message!!!
THE FOX
16-10-2005, 06:23 AM
Did you try using another USB cable?
ALSO
Check to see if the board has dry joints in the solder?
Just use a soldering iron and reflow all the points...
GOOD LUCK... :o :o :o
is there any body who can help me to repair the dead ufs3 box
Its processor is ok (tested on other box). problem on the PCB
when trying to connect " devise not found" is the message!!!
I used to have this problem with my tornado. I just replaced the FT232 IC and then it's okey.
Hope this will help.
br,
bojs
neilthirumuttam
21-10-2005, 02:54 AM
Did you try using another USB cable?
ALSO
Check to see if the board has dry joints in the solder?
Just use a soldering iron and reflow all the points...
GOOD LUCK... :o :o :o
DRIED ALLPARTS ON THE MAIN BRD
TESTED WITH ANOTHER BORD
PROCESSOR IS OK
TESTED THE TRANSISTORS DIODS REPLACED CRISTEL
I THINK IT S SW PROB
LET ME KNOW THE SW TOOLS TO READ AND RITE THE BOX
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.