Does the MasterCRD 2 LCD program simcard8?

[tarantino]

Does anyone know if MasterCRD 2 LCD can program simcard8? Does it use the same software found on ucables.com or a diferent one?

By the way what type of card is simcard8?
Is it a Funcard V wafercard (Alpha logo on chip, wafercard at90s8515-a + 24c512 with EXTRA large eeprom 512k), or just a simple Bluecard wafercard (Pic16F84(A) en EEprom 24lc64)

Thnx!
Sam

[brakk_]

for sim x8 just try with software provided with simmagic/simaster hardware (btw it have to recognize your mastercrd prog and i don't know this one), but sim x8 are expensive, u can replace them with 'classic' silver or greencard and simemu sw.

@ is just manufacturer logotype, funcard V have atmel mcu (at90xxx) like all funcards, i don't know about eproom but it's 2x larger than previous fun4 version

[tarantino]

thank you for the reply!

Ok, lets supose that I want to use program the greencard with the simemu software, what programmer should I use? "Phoenix Programmer TE21 for GoldWaffer Cards" or "Smartcards, piccards and goldwaffers cards programmer Reference: PICPROG1" Making refrence to the products found at ucables.com.

Would (at least phoenix) do to read the IMSI & KI?

This is just becouse I want to spare a few €€ buying a all in 1 programmer :)

thanks again!

[brakk_]

in your case u need a programmator who can read to extract ki/imsi keys (phoenix/smartmouse) and write your clone (JDM/pic) either, all 'multi' would have those modes just verify it can deal with greencard or silver depending simemu version you want to use.

[tarantino]

will the "MILLENIUM II -CardMaster!" at http://www.todotarjetas.com/grabadores.htm do for the job? Another thing, in the simemu.com instructions they mention a 16F877 PIC, but the greencards that I found have the "Pic 16F876 (10 Mhz) + Eeprom 24LC128 de 128K" is there any problem at all?

Thanks
Sam

[salias]

@tarantino,

as long as you have the programmer that can load the hex files below to your PIC card.

1. SIM_EMU_FL_5.00_ENG.hex
2. SIM_EMU_EP_5.00.hex

Later you can manually key in the KI and IMSI number at your phone. That simple.

Howewer you still need the reader to read the KI and IMSI.

[tarantino]

you're right, and I think I can manage the instructions. But the problem is that I don't know wich programmer to buy! And what GreenCards!!!

thanks 4 the help

[salias]

your choice to select the programmer.

"The thing, in the simemu.com instructions they mention a 16F877 PIC, but the greencards that I found have the "Pic 16F876 (10 Mhz) + Eeprom 24LC128 de 128K" is there any problem at all? "

The answer is both PIC 876 and 877 (128) are same and already built in in the green card.