PDA

View Full Version : Faid Update!!!



radmanz
16-11-2002, 09:26 AM
Hey guys,
i have a problem going down here, i have a standard mbus cable for the 82xx series and have been trying 2 re-calc FAID, it says its sucessful in updating but it still will not work. i herd though that if u place a diode somewhere on the circuit of the mbus cable that it will work!!! can anyone help me with this problem, i have tryed buildng a m2bus cable but it just doesnt want to do it for me either!!!!
OR does any one have a working schematic of a standard mbus cable that can do faid....??????

RaDmAnZ!

phantom2002
16-11-2002, 12:22 PM
try using eeprom tools 3.1 as that uses FBUS instead and will allow you to use your cable !!


Sticking a diode between Fbus TX & RX will give the required mbus, check the net for diagrams to make sure which way !!



WBR