reading a dead mcu and faid check with 3310 with rolis???

hi,joox thank you veru much 4 your software,it has made me a very nice 3310 custome flash,

But,i have a question 4 any1 else that has this problem,i recently formatted my pc,so all my flashes went aswell,there was only a couple on there anyway,so i decided 2 read the mcu+ppm area of my edited 3310 so i could do some more editing to it with flsedit.

After finishing with rolis,it sed ppm start not found and too less flash dump mcu check,ill pst a screenshot l8a,but all i want to no is,is it only sayin this becasue of the dead mcu and faid check,and is the file still editable??

cheers

spida!:D

the data contained on your flash is readable either in full or part, whether or not it is corrupt (unless hardware fault) so its just a case of finding the right tool to read it. Once you have this then your laughing.....

The file should still be editable m8!!

Rolis tries 2 get clever by checkin the CHECKSUMS!
But as the check sums are killed then it comes up wit the error!

Dunno y its comin up wit the flash dump is less U sure u read the correct addresses??

yeh defo about addresses, 20k 2 3d000

ill have 2 try l8a

cheers

4 the info guys

spida!:D

if you want to try some other readers "Knok" is a good one. Its on my site i think