FOR YASSER

Hi Yasser, I am interested in the attachment that you sent to all,But do you have any advice on the way you use it.Are there do's & don'ts? Is it straight forward to use or any problems we may come across?Do you have any instructions for newbies like myself to read so we don't make mistakes?
Thanks again Yasser for your good work.
Best wishes
Rob

Hi Rob!!!


How are you? That soft rolis 1.7b is very easy to use....Please use modified cable by Abe or dejan nk_calc cable with it. It doesn't work with dual bus cables.

After flashing, read phone and update faid...then reset eeprom by pressing SFS...that all..... Change IMEI if u want to....and recalc FAid again and resert eeprom..


I hope this helps

BR

Yasser

Thanks for that Yasser,can you tell me where i can get a modified cable which i need and how much.Also can i do 3330 v 4.30 / 4.50 + 3310 v 5.03 / 5.11 with this.
If not how do i flash these without problems.
Thanks
Rob

Yes you can unlock that phones....
Here is the cable......
And if u connect ONLY MBUS AND GND to phone.....you have MBUS cable....
If u connect all pins MBUS,RX,TX,and GND to phone,you have DUAL MBUS/FBUS CABLE THAT ALSO WORKS with ROLIS;NK_CALC etc.....

@TO OTHERS:

I modified a little my cable to make it Dualfbus/mbus......
WORKS with rolis and eeprom tools and nk_calc......tested......

I modified it because now you can use this cable with LOGOMANAGER WITH FBUS not MBUS......
because FBUS works much better with logomanager.......and faster and no problems like disconnecting when sending logos etc........
Regards....

Thanks abe, i have downloaded your program.I have a duel m/fbus lead so i can use that with your full eeprom reset program to flash 3330 v 4.30/4.50 3310 v 5.03/5.11am i right?If it is can you explain how to use?Just to make sure i have the right lead,i bought it to flash a 3210 which i was told was a f/mbus lead as the lead i had would not work on 3210.I have looked at your program and looks straight forward,but as i am a newbie i want to be sure before i take any risks.
Many thanks
Rob

Hi noiced your informative notes about unlocking.I wondered if you could give me some advice. I have got a nokia 3310 version 5.03 and am looking for a method to unlock it. I have got a flasher kit and have just found the right flash file but the instructions were a bit vague. I have also read that it can be done with a mbus cable, is this correct and if so can you give us any advice as to where i can get the software and any cable i might need.

Regards Roger

Use Logger V3.0 you can get it in earlier postings.

BR
Kid