-
Hi!
I made the following exp. with a 6210.
1. All the progs work: Logger 1.2, FAID_calc by tek, nk_calc
and Rolis 4.77/5.14
I have a 6210 here that has network just for some seconds and the nothing. It does not reset nor displays ContactService or so.
It has V5.27D and i updated to 5.26D => same as before
FAID and IEMEI correction => no effects just network for 3s
update of 5.36D with EEPROM+FAID+IMEI => reset and no network
downdate to 5.36D original EEPROM => network for 3 secs
downdate to 5.27D with diff EEPROM => no network
No wI ended up with 5.36D and original EEPROM again and 3s
of network coverage only.
WinTesla RX calibration: Everythings seems to be normal
btw: In WinTesla 7.05 I get a "cannot initialize functionality module". Does anybody know how to avoid and work around this?
Otherwise 6.43 works fine.
Any suggestion will be welcome to fix the problem (if it's not a hardware fault).
Doc
ps: Once u have a complete backup is it always possible to reflash with the orginal to set it back to what it ws before?
Some people said they were not able to flash anymore after doing "something".
Regards
-
TX Ampl. not working! Possible problem may be in a Duplex Filter!
-
i need
flash nokia 6210 05.17
-
Hi!
To Oxo Boxo:
U seem to be pretty sure about it... Any clou what can have cause this?
I just know that that phone has been crashed into a wall with approx. 45km per hour :-/ My friend was just alittle bit upset in that moment he did it.
I changed the display and also the RF shield was bend. The battery has been broken almost in two parts but is still working.
The shell itself is NOT broken (I still cannot beleive it but it's true).
Ok, I'll check the troubleshooting guide and ask the sweet winTesla again for the TX Ampli. Will c what I can find out...
Doc
-
