Siemens expert help wanted

[jerrel]

Dear Friends,

I just flashed a siemens A35 v28 with a version 25 bin using unisiemens.
Now the phone is dead.

If it try to flash ik now with the v 28 bin that i just made form another phone, unisiemens get stuck at a certain percentage.

I also triede to flash with allsiemens unlocker, but no luck keeo getting the following message..

"""""""""""""""""""""""""""""""""""""""""
COMM_LoadBoots : selected phone family is 1
TTY_OpenCOMPort : opening COM1
COMM_IsBootRunning : bootcode does not seem to be running
COMM_LoadBoots : Waiting to power on the phone ...
COMM_LoadBoots : phone is powered on
COMM_LoadBoots : internal loader version is 00.01
COMM_LoadBoots : found SIEMENS A3x lg4 v20 (1)
COMM_LoadBoots : flash ids are 008988C0 [008988C0] - F201
COMM_LoadBoots : phone ids are 59766271 [FFFF4A4C]
COMM_Write : using E:\UNLOCKSIM\SIEMENS\FLASHES\A35VERS28\SIEMENS A3X LG4 V28 - 00C00000.FLS
COMM_Write : startaddress is 00C00000 end is 01000000
COMM_Write : adjusted startaddress is 00C00000 end is 00FFFFFF
COMM_NormalWriteFlashBlock : write is not accepted
"""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""

Who can help me with this one,

Thanks

Jerrel

[][nvisible]

I had the same error message!
What I did was change the initial address from 00C00000 to 00000000.
Then it flashed ok.
The phone is still dead but I think that is because I flashed a A40 with soft from A3x eheheheh.
By the way: I could use some soft from an A40 v.28.

P.S.:Once I had a dead A35, and I've managed to fix it up.
It was a V25 inicially and some googfy tried to flash it with a V20 sw. It went dead but after some work it is alive again.
If this step isn't enough to solve your problem, tell me, I will be glad to help u out.