6210 Still says contact service after cleaning and full flash!

**Kjetil** · 05-12-2002, 04:19 PM

Hi.

Got a 6210 with minor water damage.
Cleaned and full flashed with a back up from my other 6210.
Still says contact service.

Must be HW.

Is there some tool wich can detect which area ore chip might be damaged exept the wintesla. I dont have the Fxxking dongle

I've not done a reflux because in most cases it causes more damage then repair

Please Advice

**mickey blue eye** · 05-12-2002, 08:07 PM

Run DSP test in Eeprom tools and see what happens, can point the way quite well, also check the IMEI details with eeprom or Nokia tools to check all is OK.

ag · 08-12-2002, 06:53 PM

try to use wintesla

**rustyz** · 09-12-2002, 04:07 AM

I think it should be hardware problem,try changing the IC..

**Chuks** · 10-12-2002, 08:44 AM

Use eeprom tools 3.1 by Bphreak, it will tell why your phone is still saying contact service, just click test but it likely it cobba/ccont parallel test failed, in that case just reflow those ics

Best of luck