3310 which gets very hot?

[MOBWHIZHEAD]

I have just got a 3310, It works fine, full signal, chargers ect,.. But when the phone is powered on the N502 gets very VERY hot, hot enough to burn skin??

The N502 is the Phillips version not the Hitatchi type.
Is there a easy solution to fix this fault or will i have to change the component or use my handy hammer again??

[wesam]

hi
i think you must to chang your pa with new one



when you install Hitachi PA, then you have to solder a 1K ohm resistor on R312, and remove R311 up of d300

if you install Philips PA, then you need to remove R312, and solder it to R311 up of d300(procesor)
then , have it falsh phone !
please send result
wesam