A Good Solution For You
--------------------------------------------------------------------------------
hi
Using any software reading SYSOL E700/X600 etc, using a E700 serial cable on COM1, leave the phone OFF and the battery in place. DO NOT CONNECT ANY EXTERNAL 9V to the cable. When the software ask you to turn the phone ON, press ON for 2 seconds and it will enter TAT mode and process whatever operation you selected (Read Codes, Unlock, Etc...).
When done, don't touch anything on the phone, just disconnect the cable, take the phone battery out, place any SIM card and replace the battery and start the phone. No SIM to test??? No problem, just turn the phone ON after replacing the battery and dial : *#7465625# and the 1st line tells you if the Network Lock is Active or Inactive.
That's it. Enjoy![]()
Important: PHONE HAS TO BE FULLY CHARGED
Bookmarks