Does master unlock code can remove Tamper alert?

[gsmsalers]

Hi.
I have faced problemm with unlocking motorola v50 with software version E1.12.02
After used chinese emmi clip version 1 is starts Tamper alert. Then I used emmi clip II for version xx.13.xx and new version Tamper alert remover. But still same. What is going on? Strange.
If I use motorola master unlock code from motorola code resellers
then does is can remove Tamper alert caused by emmi clip? Here is my log. Master unlock code 1 and 2 please.
imie:449270103588578
Thanks for attention

[Alinus]

what u have there is V 14 firmware...

just put a sim inside, close cover and wait until phone asks for secial code.

then u have 2 options:

1. buy log and enter special code.
2. use evolution clip and unlock it directly

[gsmsalers]

Log solution working fine. Thanks

[maddog]

Thanks i didnt know this either!

Worked a treat......thought i was in trouble as its not my phone!