How to add language pack to a full flash file?

[arnold991]

Hi Guys,
I am a newbie to the mobile technology.I have Nokia 3310 and I have upgraded its software to v 6.33.The full flash file is available at
"http://web29.bces-4010.de/nokia/fubus.php"

And the MCU and Language packs are available on the same site at
"http://web29.bces-4010.de/nokia/3310.php"

The problem is that I want to use the "language pack P",but I don't have any idea how to do that.The full flash backup v 6.33 uses "language pack B"

The MCU file v6.33 available at
"http://web29.bces-4010.de/nokia/3310.php" doesn't seem to work with the "Nokia DCT3 flasher & m2bus tools by Rolis v5.14". When I try to load the MCU I get error as follows
"Incorrect PPM file for the choosed mobile type:
-start address begins 0x330A00
-but max address are 0x330000 "

Though I choose the correct phone type from the drop down menu.However I can load the "language pack P" in the software.
Moreover if I try to use FLSEdit v0.4 by Joox I can load the full flash file but if I wanna add language it asks for language pack with .pel extension and it doesn't accept the one I downloaded from the above mentioned site.

Experienced guys ...Guide me Please(Step by Step)

Thanks in advance
"Arnold"

[Van Helsing]

You didn´t need a Fubu for upgrade, because FUBU consists of MCU+PPM+EEPRom and serves for "repair". To become Language Pack P in your 3310, flash again MCU & PPM (only)...

[anorien]

v6.33p is attached